Evaluation of controlled low strength materials containing industrial by-products

R. A. Taha, A. S. Alnuaimi, K. S. Al-Jabri*, A. S. Al-Harthy

*المؤلف المقابل لهذا العمل

نتاج البحث: المساهمة في مجلةArticleمراجعة النظراء

76 اقتباسات (Scopus)

ملخص

A controlled low strength material (CLSM) is a self-compacted, cementitious material used primarily as a backfill. It is also known as a flowable fill which is usually a mixture of fine aggregates, small amount of cement, fly ash, and water. To be classified as a CLSM, the mixture must have a compressive strength between 345 and 8400 kPa. This paper evaluates the potential use of cement by-pass dust, incinerator ash and copper slag as a CLSM. Mixtures were designed to produce a CLSM, with a low compressive strength (less than 1034 kPa), that can be excavated without using any mechanical equipment. Slump, unit weight and unconfined compressive strength tests were conducted on various mixtures. Cubical and cylindrical specimens were prepared and cured at room temperature and in sealed plastic bags. Results indicate that with a good mix design it is possible to produce a CLSM with good mechanical properties to meet design requirements. Mixing these materials with cement and sand produced better results than using them alone due to their low pozzolanic activity. Curing method and period can have considerable effects on the strength of a CLSM.

اللغة الأصليةEnglish
الصفحات (من إلى)3366-3372
عدد الصفحات7
دوريةBuilding and Environment
مستوى الصوت42
رقم الإصدار9
المعرِّفات الرقمية للأشياء
حالة النشرPublished - سبتمبر 2007

ASJC Scopus subject areas

  • ???subjectarea.asjc.2300.2305???
  • ???subjectarea.asjc.2200.2205???
  • ???subjectarea.asjc.3300.3305???
  • ???subjectarea.asjc.2200.2215???

بصمة

أدرس بدقة موضوعات البحث “Evaluation of controlled low strength materials containing industrial by-products'. فهما يشكلان معًا بصمة فريدة.

قم بذكر هذا